SATO GL 4xxe Series Installationsanleitung

INTERNAL REWINDER-DISPENSER INSTALLATION GUIDE For printer models: GL 4xxe Series Read t

10 ｺﾈｸﾀｰ 1) Mounting the printer above the rewinder A total of seven screws (cross recessed hexagonal bolt M4x10) are used to install the in

11 1) Mounting the printer above the rewinder (cont’d) If the front cover snaps into place correctly, you can proceed to further ti

12 Liner Adjust collar Dispenser 3) Mechanical adjustment of the dispenser Turn the printer ON and take it OFFLINE (by pressing the LINE button

13

2 1 General 1.1 Important information This quick guide provides important information on how to setup your new SATO product. Be sure to read thi

3 1.3 Explanation of symbols This instruction manual uses various warning icons to help you understand the safe operation of your printer. Explana

4 1.4 Contact and Document Information . Extensive contact information of worldwide SATO operations can be found on the Inte

5 1) Removing the base of the printer Make sure the printer is OFF and disconnected from the power supply and all other cables. Remove the sid

6 1) Removing the base of the printer (cont’d) The front cover can now be removed. Remove the lock shaft located at the front of printer. (D

7 1) Removing the base of the printer (cont’d) The fifth screw to be removed is shown here. The sixth and sev

8 1) Removing the base of the printer (cont’d) Finally, carefully separate the base plate of the printer from the main chassi

9 図ﾌﾛﾝﾄｶﾊﾞｰSensor cable 2) Mounting the printer above the rewinder-dispenser To facilitate easier mounting, it is recommended that you remove th