SATO GL 4xxe Series Installationsanleitung PDF herunterladen (Seite 5)

1) Removing the base of the printer

Make sure the printer is OFF and disconnected

from the power supply and all other cables.

Remove the side cover using a #2 phillips

screwdriver to remove three screws as circled in

orange. Keep these screws aside for later use

when putting back the side cover.

Slide the side cover outwards by sliding it

horizontally by a few inches first (see the red

arrow), before lifting it up and out (white arrow).

Remove the printer’s front cover by first

unscrewing the thumbscrew indicated here.

GL4xxe Internal Rewinder-Dispenser Installation

The installation procedure for the Internal Rewinder with front-mounted dispenser, involves

three major steps, that are similar to the installation of the GL4xxe internal rewinder:

1) Removing the base of the printer.

2) Mounting the printer above the rewinder and reinstallation of all removed covers.

3) Mechanical adjustment of the rewinder.

The pictures of the internal-rewinder used in this Guide are applicable for installation

processes of both the rewinder and rewinder-dispenser units.

Figure 1a. Removing the side cover

Figure 1b. Removing the thumbscrew

that secures the front cover.

Cover LH

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

SATO GL 4xxe Series Installationsanleitung Seite 5