SATO GL 4xxe Series Installationsanleitung PDF herunterladen (Seite 8)

8

3

Installing the antenna

Part(s) Required

ANTENNA ASSY, RFID, SL4M

SCREW, 6-19 HL X 1/2, PHCR,

SS410, ANSI B18.6.4

Tool(s) required

#1 Phillips + screwdriver - 12 in. lb

1. Remove the gap sensor

paddle (circled red) by sliding

it out. Set the gap sensor

paddle aside for later use.

2. Remove the media guard

(circled yellow) that is under

the gap sensor, by removing

the associated screw (circled

blue). (Figure 3a)

3. Hook the purple catch of the

antenna handle over the rod

(circled blue) situated behind

the black platen roller. The

cable should emerge at the

bottom of the printer. See

Figures 3a and 3b.

4. The antenna handle replaces

the removed media guard,

and will be secured by the

same screw (circled blue in

Fig 3d). Install the screw

through the lower support

hole and into the antenna

handle as shown.

5. Tighten the screw to secure

the antenna handle in place.

6. Re-install the gap sensor

paddle.

7. Re-install the print head

assembly.

Note

ESD (electrostatic discharge)

protection is recommended for this

step. Anti-static lint-free gloves are

recommended to be worn at all

times when handling the print

head. The gap sensor paddle will

be re-installed in the final step.

The original media guard must be

set aside and sent back to your

supplier for recycling.

Figure 3c.

The antenna emerges as

shown.

Figure 3a.

Removing the gap sensor

paddle (red) and media

guard (yellow)

Figure 3b.

Hook the antenna handle

over the metal rod that is

behind the platen roller.

Figure 3c.

Securing the antenna

handle with the screw.

purple

catch

antenna

handle

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare