SATO D508 Wartungshandbuch PDF herunterladen (Seite 119)

Unit 4: Standard Command Codes

E/Pro Programming Reference

4-67 PN: 9001096E

2D CODE COMMANDS

PDF417

FUNCTION

Specifies PDF417 of 2D code.

FORMAT

<ESC>BKaabbcddeeffffg~g, h

a = Minimum Module Width (01 to 09 dots)

b = Minimum Module Height (01 to 24 dots)

c = Security Level (0 to 8)

d = Number of Data Code Words per Digit (01 to 30)

00: Automatic (width depends on data number specified)

e = Digit Number per Symbol (03 to 90)

00: Automatic (height depends on data number specified)

f = Data Digit Number (0001 to 2681)

g = Print Data (data)

h = PDF Code Type

When omitted: PDF417

T: Truncated scale

M: Micro PDF

Place anywhere after <ESC>V but before <ESC>Q.

EXAMPLE

<ESC>V0100<ESC>H0100<ESC>BK0607400000021PDF417 PDF417 PDF417

OUTPUT

(4-41)

NOTES

The minimum module width can be set to 01 and 02; however, it may not read properly. 01, 02, and 03

are designable for minimum module height and may cause a reading problem.

If specifying “00” for Number of Data Code Words per Digit and Digit Number per Symbol, the size of

height to width (aspect ratio) will be at 1:2 based on the number of print data.

If increasing the security level, it is necessary to specify a higher value for Digit Number per Symbol or

Number of Data Code Words per Digit.

The maximum Digit Number of Data is 2681; however, it may vary depending on the specification of

minimum module size, security level, and print data type.

If the specification of parameter or number of data is not matching, printing will not be properly

performed.

Refer to Appendix: Reference Table 21 and 22 for additional information.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 289 290

Keine Kommentare

SATO D508 Wartungshandbuch Seite 119