SATO M8485S Betreibershandbuch PDF herunterladen (Seite 39)

Vertical Offset Setting

Vertical Offset is the distance down from the leading edge (the edge of the label that

comes out of the printer first) to the first vertical print position. It is always a positive

setting since making it negative would move it up and off the printable label. This

setting changes the base reference point for all subsequent label jobs. Its effect is

identical to the <ESC>A3 Base Reference point command (see page 5-19). Since the

printer moves the label in discrete steps equal to the size of the print dot, the units of

measure for Vertical Offset distance is dots. The maximum values that can be set for

the different model printers are:

Vertical Offset M-8459S M-8460S M-8485S M-8490S

Normal Length 0 to1424 0 to1424 0 to1424 0 to 2136

Expanded Length 0 to 2848 0 to 2848 0 to 2848 0 to 4272

Note: This setting can be overriden by the Base Reference Point Command, page

5-19).

1. The underline cursor will be positioned under the first digit of the Vertical Offset

setting. Use the LINE key to step setting to the desired value. The display will

increment one step for each time the LINE key is pressed.

2. Once the setting is correct for that digit, pressing the FEED key will accept the

setting and advance to the next digit. The correct value for the second digit is set

by pressing the LINE key. Once it is set to the correct value, pressing the FEED

key will accept the setting and advance the cursor to the next digit. This process is

repeated until all digits are correctly set. When the last digit is correctly set,

pressing the FEED key will advance the display to the next selection.

Horizontal Offset and Direction

Horizontal Offset is distance that the label image is shifted either to the right or left

on the label. The image is shifted to the left (when facing the printer) for a positive

setting and it is shifted to the right for a negative setting. This setting changes the

base reference point for all subsequent label jobs. Its effect is identical to the

<ESC>A3 Base Reference point command (see page 5-19), Since the printer can

only print in discrete steps equal to the size of the print dot, the units of measure for

the Horizontal Offset distance is dots.

Note: This setting can be overriden by the Base Reference Point Command, page

5-19).

VERT. OFFSET

0000

HOR. OFFSET

+0000

Section 3. Configuration

SATO “S” Print Engines 9001034 Rev E Page 3-11

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 227 228

Keine Kommentare

SATO M8485S Betreibershandbuch Seite 39