SATO M8485S Betreibershandbuch PDF herunterladen (Seite 55)

REPLACING THE PRINT HEAD

The print head is a user-replaceable item. If it becomes damaged for any reason, it

can be easily removed and replaced. Contact your local SATO representative for

information on obtaining a new print head.

Supplies needed: Flat Blade Screwdriver (Note: Some units may require

a No. 2 Phillips screwdriver)

1. Turn the printer off and remove the

power cable.

2. Open the Label Access door.

3. View the Print Head Assembly

from the front of the printer.

Locate the center mounting screw

on the top of the assembly. (Do

not take out the two outside

alinment screws!)It is accessible

through the center hole in the

Top Assembly Plate. Remove

this screw and set it aside.

4. Open the Print Head Assembly

by pushing the Head Latch

toward the rear of the printer. The

Print Head Assembly is

spring-loaded and will

automatically open as soon as the

Head Latch is disengaged.

5. Remove the ribbon from the

Rewind Spindle if necessary.

6. The Print Head should now be

loosened from the top of the

assembly by grasping either side

and carefully pulling it down and

forward.

7. Disconnect the signal and power

cables from the print head

connectors and set the Print

Head aside.

8. Carefully attach the new print head

to the connectors, using caution to

make sure the connector keys are

correctly positioned.

Retaing Screw

Access Hole

Screwdriver

Print Head

Print Head Cables

SECTION 4.CLEANING AND MAINTENANCE

SATO “S” Print Engines 9001034 Rev E Page 4-5

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 227 228

Kommentare zu diesen Handbüchern

Keine Kommentare

SATO M8485S Betreibershandbuch Seite 55

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Etikettendrucker SATO M8485S