SATO CX200 Betriebsanweisung PDF herunterladen (Seite 4)

This box allows you to set the basic operating characterics of the CX200. Two

additional Dialog boxes can be selected using the Advanced and Barcodes selection

buttons.

ADVANCED

Selecting Advanced takes you to the Advanced Printer Setup box.

This Dialog Box allows you to set the print configuration of the printer.

Print Mode - Selects the use of either Direct thermal media or thermal Transfer

media using a ribbon. If you have a CX200DT Direct Thermal printer, selecting

Transfer will have no effect as the printer always defaults to the direct thermal setting.

Sensor Type - Selects the type of sensing used for indexing the labels. The choices

are Gap for die cut labels with a gap between them, Bar for labels with an Eye-Mark

bar printed on the reverse side of the liner and None for the use of continuous media.

Backfeed - Enables the label backfeed. When Backfeed is enabled, the printer will

print a label and feed it out to the tear-off/cut position. Before the next label is

printed, it will retract the label to the first print position.

Note: When Backfeed is enabled, the printer thruput will be drastically reduced

since the printer must stop and retract before each label is printed. It is

recommended that this selection be made only if single labels are to be printed

and manually taken by the operator.

Darkness Fine Adjustment - This adjustment select the amount of heat used to

develop the image on direct thermal media or transfer the ink from the ribbon in the

thermal transfer mode. The middle (or 50%) position is set up to provide the

optmium results when using the SATO media supplied with the printer. When using

other media, it may be necessary to adjust this setting to get acceptable print quality.

Note: The human-eye is not well suited to gauging the quality level of bar codes.

It is recommended that you use a bar code verifier to ensure that you are printing

usable bar code symbols.

CX 200Windows Driver

Page 3 PN 9001051 SATO CX200 Printers

1 2 3 4 5 6 7

Keine Kommentare

SATO CX200 Betriebsanweisung Seite 4