SATO M-10E Spezifikationen PDF herunterladen (Seite 13)

SATO M10e PN 9001101 Rev. A Page 2-1

SECTION 2.

INSTALLATION

INTRODUCTION

This section of the manual has been written to help you install the SATO M10e printers and to

get started as quickly as possible. It is recommend to read each chapter in this manual before

the installation or the use of the print modules.

INSTALLATION

Remove the M10e from its packing container. The Top Cover is shipped unattached in a

separate compartment. Check to mae sure you have the following accessory items:

Careful consideration must be given when selecting the location of the printer, especially to

environmental considerations. To obtain optimum results from the M10e, always try to avoid

operation locations influenced by:

• Direct or bright sunlight, as this will make the label sensor less responsive and may

cause the label to be sensed incorrectly.

• Locations which have extremes of temperature, as this can create electrical problems on

the circuits within the printer.

• The installed location of the printer should ideally be in areas free from dust, humidity

and sudden vibrations.

CONSUMABLES

Always use SATO carbon ribbons or equivalent in the thermal transfer models. The use of

incorrect materials may cause malfunctions of the printer and void the warranty.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 81 82

Keine Kommentare

SATO M-10E Spezifikationen Seite 13