SATO M-10E Spezifikationen PDF herunterladen (Seite 55)

Section 4. Cleaning and Maintenance

SATO M10e PN 9001101 Rev. A Page 4-5

CLEANING THE AUTO LOAD SENSOR

In addition, there is one more sensor to sense when the media is correctly positioned for auto

loading. When dust, dirt, adhesive or other foreign matter interferes with the light path of this

sensors, the results is erratic paper end error signals. This sensors should be cleaned regularly,

at least every two rolls of labels.

Supplies Needed: SATO SA070 Cleaning Kit

1. Turn the printer off.

2. Open the Top Cover.

3. Release the Print Head by pulling

forward on the Head Release Latch

4. Lift up on both ends of the Label Cover

Plate at the points marked with the

purple arrows until it releases.

5. Apply SATO Thermal Print Head

Cleaner to one of the cotton swabs.

6. The sensor is located underneath the

label plate..

7. Use the cotton swab to clean any

foreign matter from the exposed

surface of the sensors.

8. Reposition the Label Cover Plate and

press down at the points marked with

the purple arrows until it snaps in

place.

Auto Load Sensor

TBA

Label Cover Plate

Auto Load Sensor

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 81 82

Keine Kommentare

SATO M-10E Spezifikationen Seite 55