SATO M-10E Spezifikationen PDF herunterladen (Seite 17)

Section 2. Installation

SATO M10e PN 9001101 Rev. A Page 2-5

MEDIA LOADING

Ribbon Loading (not applicable for the M10eDT)

1. Open the Top Cover to expose the ribbon

mechanism..

2. Open the Print Head by pulling forward on the

purple Head Latch lever on the right hand side

of the ribbon mechanism.

3. Lift the Print Head by rotating it upward and to

the rear.

4. The right hand Ribbon Supply Spindle is

spring loaded. Press outward on the spring

loaded spindle and place the new ribbon on the

left hand spindle, making sure the notches in

the core line up with the tangs on the spindle.

5. Place the ribbon on the right hand ribbon

Supply Spindle, again making sure the notches

in the core line up with the tangs on the

spindle. Release the spring loaded spindle.

6. Route the ribbon around the Print Head and up

to the take up core as shown in the ribbon

loading diagram in the Top Cover.

7. Place an empty ribbon core on the Ribbon

Take Up Spindle. The right hand spindle is

spring loaded. Press outward to provide

clearance to install the core.The ribbon leader

is attached to the ribbon by an adhesive strip.

Carefully pull the leader free and pull about 18

inches of leader from the new ribbon. The

ribbon should come off the top of the roll, ink

side (dull side) down.

8. Route the ribbon as shown in the Ribbon

Routing Diagram on the inside of the Top

Cover.

9. Attach the leader to the take up core by

pressing the adhesive strip on the leader firmly

onto the core (if the adhesive strip does not

adhere, use a small piece of tape).

10. Manually wind approximately three turns of

ribbon on the core.

11. Inspect the ribbon to make sure it is not folded

over or excessively wrinkled as it passes over

the print head.

Load ribbon supply

TBA

Ribbon Supply

Core

Drive Tang

Center Justified Ribbon

Tape to core

TBA

Ribbon Take Up Core

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

SATO M-10E Spezifikationen Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Etikettendrucker SATO M-10E