SATO M-10E Spezifikationen PDF herunterladen (Seite 29)

Section 3. Configuration

SATO M10e PN 9001101 Rev. A Page 3-7

DEFAULT SETTINGS

SWITCH SELECTIONS

All switches are placed in the Off default position for shipping. This will result in the

following operating configuration:

SOFTWARE DEFAULT SETTINGS

The printer stores the software settings upon receipt and uses them until they are again

changed by receipt of a command containing a new setting. These settings are stored in non-

volatile memory and are not affected by powering the printer off. The printer may be reset to

use the default software settings by depressing the LINE and FEED keys simultaneously while

powering the printer on. This will result in the following default configuration:

Once the default operation is completed, a DEFAULT COMPLETED message will be

displayed on the LCD panel. The printer should be powered off while this message is being

displayed (or after the beep is heard. This saves the default settings in the non-volatile memory

where they will be automatically loaded the next time the printer is powered on.

Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud

Protocol: Ready/Busy

Sensor: Gap Sensor

Receive Buffer: Multi Job

Mode: Batch/continuous

Label Sensor: Sensor Used

Backfeed: Enabled

External Signals: Enabled

M10e

Print Darkness 3

Print Speed 4 in. per sec.

Print Reference Vertical = 0000, Horizontal = 0000

Zero Slash

Auto On Line Enabled

Feed on Error Enabled

Feed Reprint Enabled

Priority Command

DEFAULT COMPLETED

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 81 82

Keine Kommentare

SATO M-10E Spezifikationen Seite 29