SATO M8485S Betreibershandbuch PDF herunterladen (Seite 29)

SECTION 3.

CONFIGURATION

PRINTER DIP SWITCH CONFIGURATION

DIP Switch Panels

There are three DIP switches (DSW1, DSW2 and DSW3). These are located inside the

cover. These switches can be used to set:

• RS232C transmit/receive parameters

• Thermal transfer or direct thermal mode

• Label sensor enable/disable

• Head check mode

• Hex dump mode

• Receive buffer size

• Operation mode

Each switch is an eight section toggle switch. The ON position is always to the top. To

set the switches, first power the unit Off, then position the DIP switches. Finally, after

placing the switches in the desired positions, power the printer back on. The switch

settings are read by the printer electronics during the power up sequence. They will

not become effective until the power is cycled.

RS232 Transmit/Receive Setting

Data Bit Selection (DSW1-1). This switch sets the printer to receive either 7 or 8

bit data bits for each byte transmitted.

Parity Selection (DSW1-2, DSW1-3). These switches select the type of parity

used for error detection.

DSW1-1 SETTING

Off 8 data bits

On 7 data bits

12345678

OFF

DSW1

DSW1-2 DSW1-3 SETTING

Off Off No Parity

Off On Even

On Off Odd

On On Not Used

12345678

OFF

DSW1

SATO “S” Print Engines 9001034 Rev E Page 3-1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 227 228

Keine Kommentare

SATO M8485S Betreibershandbuch Seite 29